Hi all:

I've recently acquired a large Allen 903 model - 3 manual, about 75 stops. I believe it has 3 computers with 6 channels and a bunch of other gizmos I have yet to figure out. It came with a single TC Electronics M350 reverb and effects processor that the previous owner added on two of the channels which sounds fabulous, but the other four channels don't have anything, so only some of the stops are 'reverbing'.

I also have access to two Allen MOS 301's that would benefit from what the TC M350 has to offer.

My question is this: should I just be buying more TC M350's or is there a multi-channel equivalent that would be better and/or more economical for my Allen 903 (if so, I'll just hand-down the existing TC M350 processor to one of the Allen 301's). I've seen TC-M350's for as little as $200 plus shipping, but I don't know what else is out there or if it's any good.

Your advice is appreciated!

JamesT