Check that the red wire of the Reverb switch cable is not cut somewhere.
Both ends : Molex connector on amp and lower lugs of the reverb tabs.
JP
Hi again
I finally had a chance to look at this properly. Well all I had to do was unplug and replug that Molex connector on the amp, and the switches are back in business.
Thank you for your help.
Hi there, the issue is as per the subject line.
I've had a look at the molex connector that appears to connect these switches to the vibrato amp, it doesn't look dirty or anything.
Looks like you’re enjoying the discussion, but you haven’t signed up for an account yet.
Tired of scrolling through the same posts? When you create an account you’ll always come back to where you left off. With an account you can also post messages, be notified of new replies, join groups, send private messages to other members, and use likes to thank others. We can all work together to make this community great. ♥️
We process personal data about users of our site, through the use of cookies and other technologies, to deliver our services, personalize advertising, and to analyze site activity. We may share certain information about our users with our advertising and analytics partners. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Leave a comment: