Speaker and Driver opinions

[Bobmann]

Doing more cleaning out. Came upon 4 drivers that I forgot I had. I hooked each of them up to my 122 and they all work. The V-21s looked used, the Eminince and Leslie drivers both look unused.

Leslie Ferro Fluid 100 ohm
Eminence
V-21 with 220 code, Jensen
V-21 with 285 code, Rola
an unmarked driver that has "8" on a label and was in a box marked "8 ohm driver". Absolutely no other markings on this driver anywhere.

Who has input as to which of these are more desirable than the others, and why?

Also several 15" speakers, with Rola and C.T.S codes. Probably came out of parted out H cabinets. Some with square magnets, some with horseshoe magnets.
How do I determine what ohm value these are?
A couple p/n 514-052308 that are on Hammond web site as a replacement to be used in tube amp Leslies, and are 16 ohm.
A Radio Shack 40-1315 that is 8 ohm, 100 w. 1135 g ceramic magnet, 5 cm voice coil.
Any of these have any value?

I am going to put these on Ebay; I can use the $.
Thanks for the opinions and input.

[skydawg]

Hi Bob,I always thought that all V-21`s were Jensens...that`s not the case?

[Bobmann]

Hi Bob,I always thought that all V-21`s were Jensens...that`s not the case?

Appears not. One has a Jensen code, the other a Rola code, but both are stamped "V 21"

I put that Leslie Ferro Fluid driver on ebay, so far not much interest.
I also put a couple sets of smooth DB, both with a start bid of $150. One set only got one bid, the other bid $2 more.
I would have thought that they would have been more in demand than that.

[tpappano]

Just sent you a message via eBay, can they be made to work on a BC?

Thanks!