Help with a Salvaged Leslie tremolo unit

[Doronsegal]

Hi all,

I am new to this forum , nice to meet you all!

I had Salvaged an old Leslie tremolo unit from an old Hohner Organ that didn't work, Tremolo unit worked perfectly before, I had disassembled it and would like to build a cabin for it,
Im still at my early days of DIY project so any Information will help.I know that it had been asked around a few times, But my model is different and I could not fully understand the process. I'm adding some Photos of it. I also have the with between chorale and tremolo mode, Three lines are going out from it Yellow-Green, Blue, Red
Thank you very much, and stay safe in this crazy days.

Best,

Doron

[tpappano]

Could you take a couple of pics that show the whole thing? That might generate some ideas on how to best enclose it. Welcome to the forum!

[Drawbar Dave]

Also a close up of that sheet of paper stuck on there. Is it a Leslie 10X?

[Doronsegal]

Hi all and thanks for you reply, Ill add more pictures now, Dave I was not sure which paper you were talking about

[Drawbar Dave]

Yep the fourth pic is what I meant. Some people keep it upright and build a Leslie 16 type enclosure. It looks like you have a crossover on there to protect it from low frequencies. You'll need to know whether there is a relay in there to switch between the motors or whether it is located in the organ. Are you planning to use if for guitar or keys?

[Doronsegal]

Hi Dave,
Thank you again for your help. I am planning to use it mainly with keys, Fender Rhodes and synth sounds