I'm undertaking the dreaded foam removal on my '64 A-100. Fortunately it appears the foam has more crumbled than turned into the even...
54 results in 0.0117 seconds.
-
A-100 dreaded foam removal
Hi Folks,
I'm undertaking the dreaded foam removal on my '64 A-100. Fortunately it appears the foam has more crumbled than turned into the even... -
Hammond A100 dead percussion (not even a ping!)
Hi everyone,
After reading numerous posts here about A100 percussion issues, learning tons of information, I finally joined the forum ... with the...Last edited by SoSu; 02-25-2021, 10:01 AM. -
HELP and ADVICE for a Newbie purchasing an A100
HELP and ADVICE for a Newbie purchasing an A100
I hope to travel from Canada to Maine to pick up an A100 and Leslie. In June, 2019, I heard... -
Hammond A-100 low freq hum goes away while touching the "C" terminal post
I have changed tubes and many of the suspect caps in trying to reduce the very low frequency hum. The hum is audible through both the internal speakers... -
Hammond Power switch nut size
Hello everyone,
My Hammond A-100 is missing the nuts that secure the motor start/run switches to the organ. Because of this, they fall down... -
Switching Between Combo Preamp and Hammond
I am looking for something which would:- receive a six pin connection from the Hammond A-100,
- receive a six pin connection from the Combo Preamp and,
- allow
-
adding second leslie (145) to A100 and 251
Hey guys,
I recently acquired a leslie 145 (220v). I want to hook it up to my A100 which already has a 251 connected to it. The 251 is connected... -
A100 sounds gritty. Bad Tube?
I have a 1965 A100.
The tone from the top of the leslie sounds gritty. And not in a good way.
My preamp levels on the Leslie... -
Hammond H111 Free - Is it a deal or not?
I have been offered a Hammond H111 for free. I have owned three Hammonds over the years - one tone-wheel and the two others basic solid state electronics.... -
A100 hums like crazy during warmup.
Hey, y'all.
My Hammond A100 starts humming like crazy, I mean like a amp with the guitar chord plugged in and a thumb on the tip of the... -
Needing Advice - A100 Vibrato weak sounding, almost non-existent?
Hi All! You all here in this gracious forum helped me get my Hammond M come alive again some years ago, and this time I'm back having just acquired a... -
A100. Reverb stops after about 20 minutes
Hi. I have a 1966 Hammond A100. After about 20-25 minutes of use the reverb starts to dwindle in strength then stops altogether. Once powered down and... -
A100 Keycomb felt alternative fix and polish help
Hey guys,
I decided to thoroughly clean/fix some parts of my A100 and I need some help.
About 4 years back I had serious... -
Mylar (red) capacitors from a "H100" tone generator for recap of an '59 A100TG?
hi,
this is my first post.
i recently bought a chopped A 100 for stage gigs that seems to have a lot of "stage mileage".... -
Hammond A100 Leslie Sound Options
Hello everyone!
I've been searching this but I'm not sure if I've worded it correctly so I haven't found an answer yet :P.
I'm about to buy...
