 Random files - Legacy Archive |
DSC02846.JPG290 views
|
|
Refelting 8249 viewsUse a tapered tool to line up the screw holes in the front panel and the lower felt strip blade, hold it in place while you get a screw started in an adjacent hole. Think it was fun taking out all those screws? Even more fun now, you have to get them started in the free-floating felt strip blade. Be careful not to knock the felt strip blade out of position. It helps to hold down the keys if you have a spare hand.
|
|
1261 views
|
|
A-102 photo 5535 viewsLoosen, do not remove, the screw that holds the key channel secure. Slide the channel up to remove. Make sure the new channel is properly seated on the studs located near the screw. Tighten the screw. The hard part is holding the camera in your mouth.
|
|
Vacuum cleaner, a very handy item for this job.179 viewsAt this point the upper manual is completed and I'm vacuuming 54 years of funk out of the lower manual. Note the 2 x 4 block used to hold the manual up for servicing. There are two, one for each side.
|
|
DSC02851.JPG278 views
|
|
Part of the voice switching network of HT2214 viewsThis shows a part of the voice switching network for the solo manual on my HT2R. The stops marked with red are quite a bit softer than others.
|
|
1573 views
|
|
 Last additions - Legacy Archive |
1023 viewsNov 13, 2010
|
|
558 viewsNov 13, 2010
|
|
570 viewsNov 13, 2010
|
|
505 viewsNov 13, 2010
|
|
638 viewsNov 13, 2010
|
|
697 viewsNov 13, 2010
|
|
849 viewsNov 13, 2010
|
|
315 viewsAug 07, 2010
|
|
