I recently corrected a distortion issue that resulted in me recapping amp, replacing driver, and woofer.
I do have the leslie control hooked to the volume pedal by way of a kick switch. I've noticed that when I kick the switch to fast it will run until I lower the volume. When it gets to a certain low level, the fast motor stops. The strange part is when I raise the volume, the fast motor reengages. Has anyone ever heard of such a thing? I'm thinking cord from kick switch to organ or the amp, 6pin leslie cord.
The reason I say leslie cord is because when I start the organ, the leslie always start fast as it warms up and then cuts off if the switch is set to off. It stays on if the switch is set to on.
Any feed back is greatly appreciated.
thanks,
Johnny
I do have the leslie control hooked to the volume pedal by way of a kick switch. I've noticed that when I kick the switch to fast it will run until I lower the volume. When it gets to a certain low level, the fast motor stops. The strange part is when I raise the volume, the fast motor reengages. Has anyone ever heard of such a thing? I'm thinking cord from kick switch to organ or the amp, 6pin leslie cord.
The reason I say leslie cord is because when I start the organ, the leslie always start fast as it warms up and then cuts off if the switch is set to off. It stays on if the switch is set to on.
Any feed back is greatly appreciated.
thanks,
Johnny
Comment